Oil pump can not work alone, it must be integrated with the pipeline, generator to work. Oil pump, pipeline and motor constitute the main process of the pump station. Therefore, to correctly design and manage the pump station not only need

A pump is a mechanical device that is used to move a liquid or any liquid displacement action. Now has become a pump in any industry indispensable name. Your name is any production or work area and you will have a hard time finding it miss

It is very important to start the gear oil pump correctly, otherwise it will damage the pump. The following is some common sense before starting, please pay attention to it: I. Preparation before starting: 1. Test whether the motor is turn

Under normal circumstances, high temperature oil pump seal oil leakage is often caused by the following reasons, take a look at the situation you encounter belongs to which one. If not, please contact our customer service. (1) the design a

What is cavitation phenomenon of pump? How to prevent cavitation? Answer: The suction power of the centrifugal oil pump depends on the pressure on the suction surface and the low pressure difference formed after the impeller throws out the

What is a screw pump? How does the screw pump work? A: Screw pump is also a positive displacement pump, also known as screw oil pump; Divided into three screw, twin screw and single screw; It is by a few intermeshing screw volume changes t

The scale samples were taken from the pump seal chamber and titrated with hydrochloric acid. In the process of titration, it was found that the scale of the high-temperature oil pump was not gradually dissolved as expected, but only a smal

The pump body of type RY high temperature oil pump and the end covers on both sides are hard seals with direct contact. If the flatness of the contact surface cannot meet the specified requirements, the pump is easy to inhale air at work. (

1, gear oil pump internal parts wear will cause internal leakage. The leakage area between the floating sleeve and the end face of the gear is large, which is the main part of internal leakage. This part of the leakage accounted for 50 to

Note the following: 1, high temperature oil pump transmission shaft and prime mover output shaft installation using elastic coupling, its coaxiality deviation should be less than 10. LMM; If the shaft sleeve type coupling coaxiality deviat